Precautions for the use of Anhui Heli forklifts
The performance of Anhui Heli forklift has been affirmed by many consumers in the society, so what are the precautions when using Heli forklift? The following is the reply of the technical service personnel of Anhui Leading Forklift Parts Co., Ltd. I hope it will be helpful to you.
1. Before starting, observe the surroundings of the forklift, and start with the whistle after confirming safety. For vehicles with air pressure or braking, the brake air pressure gauge must reach the specified value before starting.
2. The forklift driver in the factory must strictly abide by the "Factory Traffic Safety Management Standards" and the "Safety Production Code" when driving.
3. Check the technical condition of each part of the vehicle according to the specified items and standards to keep the forklift in good condition.
4. Do not raise the forks too high when the truck is driving in the factory. When entering and leaving the job site or driving, pay attention to the obstacles that are not obstructed. Sudden braking and sharp turns are prohibited.
5. When the forklift in the factory is driving, the height of the bottom of the forks from the ground should be kept 300-400mm, and the mast must be tilted backward.
6. When the forklift truck in the factory is driving at more than 7° and going up and down at a speed higher than the first gear, the foot brake shall not be used except under special circumstances.
7. After parking the forklift in the factory, it is forbidden to hang the cargo in the air. After unloading, the crane should be lowered before driving.
8. When the forklift is working in the factory, it must rise and fall smoothly. If necessary, it must be sealed firmly with ropes and chains. The cargo must be forklifted strictly according to the value specified in the load curve of the truck, and overloading is strictly prohibited.
9. When the car is running, no one is allowed to get on and off the car, and it is strictly forbidden to stand on the fork leg.
10. When the forklift in the factory loads goods, the weight of the goods should be shared equally on the two forks, the goods should not be skewed, and one side of the goods should be against the shelf. Small items should be placed in the collection box (board) to prevent them from falling. The items contained in the plug-in vehicle shall not obstruct the driver's sight.
11. In the factory area and construction site, the speed should not exceed 10 kilometers per hour, and when entering and leaving the factory gate, workshop, warehouse and construction site, the speed should not exceed 3 kilometers per hour. Pay attention to the forklift when driving to prevent it from scratching and hurting people.
12. When lifting, lifting or driving the forklift in the factory, it is forbidden for anyone to stand on the forks to hold objects or perform balance. When the forklift is lifting, no one is allowed near the cargo.
13. When the fork is approaching or evacuating objects, the speed should be slow and steady, pay attention to the wheels not to crush the objects, skids (pallets) and forks do not scratch the object support personnel.
14. It is strictly forbidden to use forks and other accessories to lift personnel to engage in high-altitude operations. Electric forklifts are prohibited from single-fork operations or forks to top or pull objects. It is forbidden to use brakes to inertially slide round or easy-to-roll objects. The fork lifts the pallet to unload. High-speed fork picking is prohibited.
15. When the forklift is raised and lowered in the factory, the lifting frame should be tilted against the ground, and the lifting frame should not be tilted forward.
16. When the factory parks the vehicle in the factory, in the workshop or on the construction site, the driver is not allowed to leave the vehicle. If you need to leave the vehicle temporarily, you must remove the key and the switch.
When using Anhui Heli forklifts, forklift drivers should develop good usage habits and be familiar with various usage techniques. When facing accidents, they should not panic to avoid accidents.
