In the warehouse, workshop, workshop and other places, short distance operation is required, so forklifts will be selected. Forklifts need to make frequent u-turns and astern during short distance operation. When the forklift is turning and reversing, the driver's sight will be limited to some extent. Due to inadequate observation and other reasons, it is difficult to grasp the direction and position of the forklift. As a result, reversing is not as easy and convenient, flexible and accurate. There are more accidents when reversing or reversing a vehicle. After years of operation experience, small make up remind the driver to be careful when turning and reversing the forklift operation. The main points for attention are as follows:
1. Turn around:
When making a u-turn, the forklift should try its best to choose a wide road surface or site and make a u-turn from right to left. When making a u-turn, we should observe the situation before and after, send out the u-turn signal in time, and make a u-turn without affecting other vehicles. If you cannot adjust it once, when you need to reverse, you must carefully observe the situation behind the car, properly control the speed, and sound the horn.
2. Astern:
When reversing in the workshop, warehouse, yard, narrow road and other areas, there should be a special person standing at the back side of the forklift truck (a position easy for the driver to find) to direct the reversing. When reversing a forklift, it is necessary to pay attention not only to the situation behind the vehicle, but also to the position of the front wheels, so as to avoid the parts in front of the vehicle hitting obstacles. Remember, forklifts are not allowed to reverse at intersections, Bridges, tunnels, steep slopes and dangerous areas.
Usually, when reversing, you should first stop the forklift, see the surrounding situation clearly, choose the reversing route and target, and pay attention to whether there are vehicles, pedestrians, animals before and after. If you encounter obstacles on the reverse, when necessary, the driver should get off to see, and then according to the situation needs, the transmission will be hung in the reverse of the appropriate position, horn, and choose the appropriate driving posture and operation method. When reversing should pay attention to control the speed of the car, not fast or slow, in order to prevent the starting machine is weak and stall, or reversing too hard and cause harm.
