Apr 17, 2020 Leave a message

Where is the reason why clutch release bearing is easy to be damaged

In practical experience, although the driver was strictly required to drip oil to the separated bearings once a day, the operation was not only tedious, but also the bearings were often damaged. According to the analysis, because the high temperature of the engine is transferred to the separation bearing, and the high-speed rotation of the bearing will also produce high temperature, under such conditions, the lubricating oil is difficult to stay in the bearing, the bearing in the high temperature state of continuous work, and because the lubrication conditions are not good, so the separation bearing is prone to frequent damage.


In the engine does not disintegrate the method of filling oil:

First open the clutch cover, observe the release bearing wear, if confirm there is no damage or wear not overrun, bearing, remove the clutch pedal, adjust the connecting rod shaft pin, make the release bearing and its position, after the return to compare with the beak to the hole of the bearing grease gun loaded with butter, until the bearing oil overflow, and then a little twist of bearing, oil again, repeat the above work, with a little butter until around the bearing are overflow, then make the bearing rotation, observe the oil amount, such as moving bearing resistance, that bearings have been filled with butter. Then remove the small amount of butter that spilled around the detached housing and reassemble the removed pins and clutch covers.


Fuel injection method for engine disintegration:

The engine disintegrated to expose the assembly parts of the separated bearing and bearing seat, with the nozzle butter gun to the small oil hole below the inner ring of the separated bearing seat, when the bearing has butter overflow, turn the bearing, until the bearing has a circle of butter overflow.


Send Inquiry

whatsapp

skype

VK

Inquiry